Clarion UNGO MS2105, Owner'S Manual

5

3. REMOTE TRANSMITTER 

3.1 Remote Transmitter Layout

The Ungo MS2105/MS2107 comes with one or two  VariCode

3

Remote Transmitters

used to control the system’s features. Each time a transmitter button is pressed, the
LED will flash to indicate that a transmission is taking place. 
Button 1 Arms the system and locks the doors.*
Button 2 Disarms the system and unlocks the doors.*  If the optional Driver’s Door
Priority Unlocking feature is installed, pressing Button 2 Disarms the system and
unlocks only the driver’s door.  Pressing Button 2 again unlocks all doors. 
Button 3 Activates the system’s auxiliary 1 output (usually used for trunk release).*
Button 4 Activates the system’s remote start feature.  
The Level Shift Button temporarily changes the function of buttons 1-4 allowing
expanded operation and multi-car compatibility.  Each time the Level Shift button is
pressed, a new level of commands are accessed up to a maximum of four levels (Level
Shift three times).  Note: pages 3 and 4 are reserved for channel expansion modules or
multi-car operation.  

See your Authorized Ungo Dealer for details.

*  Optional feature

3.2 Battery Replacement

Your Ungo remote transmitter uses a 12 volt alkaline battery (type 23A), which will need
to be replaced from time to time.  Under normal conditions, the battery may last more
than 6 months before it needs replacement.  When your remote transmitter’s battery
needs replacement, you will notice a decrease in operating range or a decrease in the
brightness of the transmitter’s LED indicator.
To change the battery, remove the 2 screws at the back of the transmitter and carefully
separate the top and bottom halves of the transmitter case.  Insert the new battery,
carefully observing proper polarity, then replace the cover. 

Auxiliary 1

Auxiliary 2 
w/ Shift

Arm/Lock

Silent Arm
w/ Shift

Disarm/Unlock

Silent Disarm
w/ Shift

Level Shift

Start

MS2105 owner.qxd  8/25/2003  4:21 PM  Page 5