9
© 2 0 0 6 d i r e c t e d e l e c t r o n i c s , i n c .
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet®
switch within 10 seconds.
The status LED will light steadily if you are entering Valet
®
Mode
and will turn off if you are exiting Valet
®
Mode.
panic mode
If you are threatened in or near your vehicle, you can attract
attention by triggering the system with your transmitter. Just
press
for two seconds to enter Panic Mode. In Panic Mode,
the horn will honk (if connected) and the parking lights will flash
for 30 seconds. To stop Panic Mode at any time, press
on the
transmitter again.
rra
ap
piid
d rre
essu
um
me
e llo
og
giic
c
This Pro Security system will store its current state to non-volatile
memory. If power is lost and then reconnected, the system will
recall the stored state from memory. This means if the unit is in
Valet Mode and the battery is disconnected for any reason, such
note:
In order for Panic Mode to be effective, the vehicle’s
horn (or optional siren) as well as the vehicle's parking
lights must be connected.
➜
DRW-35
