3-18
Operator Controls
Engine Stop
Run the engine at idling speed briefly before shutting it off. Turn the
key switch to the "OFF" position to shut the engine down.
Seat Adjustment
The fore and aft adjustment lever is located
on the front under the seat. To unlock, pull
the lever to the left and adjust the seat,
release the lever. Be sure that the seat
locking mechanism is engaged. The back
declining adjustment lever is located on the
left side of seat cushion. Pull the lever up
and adjust the back, release the lever. Be
sure that the back locking mechanism is engaged.
CAUTION
!
Never adjust driver's seat while truck is moving, to avoid
the possibility of loss of control and of personal injury.
Parking Brake
Activates brake operation.
Check the parking Brake
(C15-35)
:
To apply the parking brake, push
the pedal down with your left foot until pedal
stops. The parking brake release is located
just above the brake pedal as shown. To
release the parking brake, pull upward.
(C40-80)
:
The brake is applied by pulling
the lever uppers. It is released by pushing
downs.
CAUTION
!
Always apply parking brake before leaving truck.
WARNING
!
Never operate your lift truck with a defective parking brake.
Hour Meter
Starting the engine also starts the operating hour meter. Use the hour
meter reading to perform prescribed maintenance.
Fore and
Aft Adjust
Back declining
adjustment
C15-35
C40-80
Parking
Brake
Apply
Parking
Brake
Apply
Parking
Brake
Release
Parking
Brake
Release
Summary of Contents for C15 D
