10
ELECTRICAL CONNECTIONS
Connect the mains lead to a 230 Volt (50Hz) single phase 30 amp electrical
supply, through a suitably fused isolator.
IMPORTANT: The wires in the mains lead are coloured in accordance with the
following code:
Green & Yellow -
Earth
Blue
-
Neutral
Brown
-
Live
• Connect GREEN & YELLOW cord to terminal marked with a letter “E” or Earth
symbol “
” or coloured GREEN or GREEN & YELLOW.
• Connect BROWN cord to terminal marked with a letter “L” or coloured RED.
• Connect BLUE cord to terminal marked with a letter “N” or coloured BLACK.
We recommend that this machine is connected to the mains supply via a
Residual Current Device (RCD)
If in any doubt, DO NOT attempt any connections or repairs yourself. Consult
a qualified electrician, your local Clarke dealer or Clarke International on:
020 8988 7400 or e-mail Service@clarkeinternational.com
CABLE EXTENSION
Always use an approved extension cable suitable for the power rating of this tool (see
specifications), the conductor size should also be at least the same size as that on the
machine, or larger. When using cable reel, always unwind the cable completely.
WARNING: DO NOT CONNECT TO A DOMESTIC SYSTEM VIA A 13 AMP
PLUG.
WARNING: THIS APPLIANCE MUST BE EARTHED
IMPORTANT
If a cable extension is needed, it is essential to comply with the following data.
Voltage
Extension length
Cable section
230V
up to 20 Meters
2.5mm
2
230V
20 - 50 Meters
4mm
2
Summary of Contents for 20CI
