Page -16-
Clarke Owner's Manual -Vision 38 I\32 I/IX - 26 I/IX
Figure #13
How To Charge The Batteries
WARNING: Charging the batteries in an area
without adequate ventilation
could result in an explosion. To
prevent an explosion, charge the
batteries only in an area with
good ventilation.
WARNING: Lead acid batteries generate gases
which could explode. Keep
sparks and flames away from bat-
teries. NO SMOKING!
WARNING: Failure to disconnect the AC plug
from the wall receptacle before
connecting or disconnecting the
DC connector on the charger
could result in an explosion. Al-
ways disconnect the AC plug
from the wall receptacle before
connecting or disconnecting the
DC connector on the charger.
To charge the batteries, follow this procedure:
1. Put the charger on a flat surface. Make sure the
vents on the sides are at least two inches away from
walls and other objects. Make sure there are no
objects near the vents on the bottom of the charger.
2. Set the parking brake by putting it into the down
position. See figure #11. Make sure the key switch
is “OFF” position.
3. Disconnect the battery pack connector from the
control housing connector. See figure # 12 .
4. Connect the DC connector on the charger to the
battery pack connector. See figure #13.
5. Connect the charger to a properly grounded single
phase (3-wire) wall receptacle having the voltage,
frequency, and ampere capacity specified on the
nameplate of the charger.
For more instruction on the use of the charger, read the
instruction book supplied with the charger.
HOW TO PREPARE THE MACHINE FOR OPERATION
Figure # 11
Figure #12
Summary of Contents for 26I-00260A
Page 29: ...Clarke Owner s Manual Vision 38 I 32 I IX 26 I IX 29 NOTES...
Page 62: ...NOTES...
