6
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
PREPARATION FOR USE
1. Screw the quick fit air intake
coupling to the nailer as shown on
the right.
PRELIMINARY CHECKS
Make sure that the air supply is not connected to the nailer. Do not put any
nails in the air nail gun until directed to do so in the following procedure.
It is essential that the air nail gun is lubricated before each use.
1. Use the CLARKE airline oil provided with your nailer to lubricate the safety
yoke and trigger mechanism. Do not use detergent oils or any oil that
contains artificial additives these may cause the nail gun to malfunction.
2. Place 2 or 3 drops of oil in to the air intake twice a day when the nailer is
being used.
3. Check all of the nailers screws for tightness.
CONNECTING THE AIR SUPPLY TO THE NAILER
Ensure you are wearing eye protection before connecting the air supply.
1. Push the hose from the compressor on to the nailer. The collar on the hose
connector will slide forward and click in place.
2. Refer to the air compressor instruction book for the starting procedures of
the compressor. Set the compressor output to 5.5 Bar (80 psi).
• Check that the nailer does not leak air.
CHECKING THE SAFETY MECHANISM
1. Hold the nailer in mid-air pointing downwards and pull the trigger.
WARNING: ALWAYS CHECK THE SAFETY MECHANISM BEFORE USING THE
NAILER. TO DO THIS, CARRY OUT THE SAFETY CHECKS IN THE PROCEDURE
DETAILED BELOW. WHEN USING THE NAIL GUN ALWAYS WEAR EYE
PROTECTION.
Summary of Contents for 3110397
Page 16: ......
