Clarke 3503590, Assembly Instructions Manual

13

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

4. Repeat this with the tubes at each shoulder of the frame, wrapping the 

edges of the door panel around the tubes and re-connecting the frame 
components.

5. Hook the pre-assembled ratchet tie-down to the corner bottom (#6) and 

tighten the ratchet until the door cover is reasonably tight.

6. Repeat the same procedure to install the back panel.

STEP 6: INSTALLING THE MAIN COVER

1. Lay the cover on the ground next to the frame noting that the inside of the 

cover is a different colour and has pockets for the lower cross rails. The 
tensioning straps will be nearest the front and rear of the frame.

2. Tie a rope to the eyelets on the cover, one each side. Another rope in the 

middle helps if another person is available.

3. Pull the cover over the frame using the rope as in Diagram K, making sure 

to centre the cover on the frame. There should be an equal overhang on 
each corner.

4. Assemble a ratchet tie-down (#28) to the strap ends at the four corners of 

the cover. Ratchet a few times to secure the strap.

5. Attach the hook on the ratchet into the hole on the bent corner leg to 

loosely retain the cover in position.

6. Slide the bottom cross rails through the fabric pockets and re-attach with 

the clamps at each leg. Repeat this on the other side. Push down on the 
cover rails to tension the cover before tightening the securing bolts 
completely.