Page 4
CLARKE TECHNOLOGY Extractor Tools Operator's Manual
The extractor tools are tools for cleaning the carpet. When
used with an extractor, the tools apply cleaning solution
to the carpet, and removes dirty solution and soil from the
carpet.
•
Use the 4" metal and 4" plastic hand tools to clean
stairs and small areas of carpet. These tools clean a
path 3½ inches wide.
•
Use the 8" plastic wand and 12" metal wand to clean
edges of a room and larger areas of carpet. The 8" wand
cleans a path 8 inches wide. The 12" wand cleans a path
12 inches wide.
•
The extractor has controls to start the pump for the
solution and the motor for the vacuum. The floor tool
has a control to release the solution.
INTRODUCTION
How To Operate The 4" Hand Tools
NOTE:
Instructions for preparation and opera-
tion of your extractor are given with the
extractor.
CAUTION: Clarke Technology will not be held
liable for damage to the carpet, or poor
results because of operator's lack of
training.
To operate the 4" hand tools, follow this procedure:
1.
Connect the vacuum hose to the hose connector on
the extractor and to the end of the vacuum tube on
the floor tool.
2.
Connect the solution hose to the extractor and the
floor tool. To fasten the quick-disconnect, slide the
knurled collar on the female coupling away from the
opening. Push the male coupling into the female
coupling.
3.
The switch that activates the motor for the pump is
on the extractor. Put the switch in the "ON"
position.
4.
The switch that activates the motor for the vacuum
is on the extractor. Put the switch in the "ON"
position.
5.
Begin at the right-hand corner of the area to be
cleaned.
6.
Press the solution release lever. Pull the tool
toward you at a slow steady speed.
