Clarke 6470683, Operation & Maintenance Instructions Manual

11

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

5. Before refitting the water tank, 

check to confirm the indicator 
float moves freely. 

6. Replace cover and refit the water 

tank.

NOTE: 

The unit will not operate 

unless the water tank is fitted 
correctly.

CONTINUOUS DRAINING

This function enables continuous dehumidifying without having to empty the 
water tank.

PREPARATION FOR CONTINUOUS DRAINING:

1. Locate the water drain cap on 

the rear of the machine and 
unscrew.

2. Fit the drainage pipe supplied on 

to the water drain outlet.

3. Always replace the drain cap 

when not using the continuous 
draining procedure.

NOTE: 

The pipe should have an 

internal diameter of 9mm and an outer diameter of 12mm.

NOTE: 

Make sure that the drain pipe always runs downhill away from the 

dehumidifier and the end should be a minimum of 10cm below 
the water drain outlet.

NOTE: DO NOT

 submerge the end of the pipe in water, as this may cause 

water to be drawn back up into the machine.