Clarke 6470683, Operation & Maintenance Instructions Manual

9

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

SELECT MODE

SETTING OF TIMER - OFF 

• When the dehumidifier is running, press 

the TIMER button to adjust the time from 1 
hour to 24 hours, pressing once for each 
hour. If the time exceeds 24 hours, the 
count will reset to 1 hour and will start the 
cycle again.

• At the start of the set time, the 

dehumidifier will turn itself off 
automatically.

SETTING OF TIMER - ON

• When the dehumidifier is in standby mode, press the TIMER button to 

adjust the time from 1 hour to 24 hours, pressing once for each hour. If 
the time exceeds 24 hours, the count will reset to 1 hour and will start the 
cycle again.

• At the end of the set time, the dehumidifier will turn itself on 

automatically.

AUTO MODE

• Press the MODE button and select AUTO, 

if the room humidity is higher than the set 
humidity or is b5% or -5% of the 
set humidity the compressor will start and 
the fan will run at the set speed. If the 
room humidity is lower than the set 
humidity by -5% then the compressor will 
stop but the fan will run at the set speed.

NOTE: 

The default set humidity value is 50%.

CONTINUOUS MODE

• Press the MODE button and select CONTINUOUS. No matter how high 

the relative humidity in the room is, the compressor will start, the fan will 
run at high speed and the air speed can be regulated via the AIR SPEED 
button.

DEHUMIDIFIER DRYING MODE

NOTE: 

The whole procedure takes approximately 1 hour.

HOW TO START

• Press the DRYING button to start drying within the dehumidifier.