8
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
HOW TO CHARGE THE BATTERY
NOTE:
New batteries must be charged before use.
1. Connect the battery charger to
the power supply.
• The green LED comes on.
2. Put the battery into the charger as
shown.
• The red LED comes on and the
green LED goes out.
• Charging takes approximately
45-60 minutes.
• When fully charged the green LED comes back on.
3. Disconnect the charger from the power supply.
FITTING THE BATTERY PACK
TO ATTACH THE BATTERY
1. Slide the battery into the stapler/
nailer until it clicks into position.
TO REMOVE THE BATTERY
1. Push and hold the release button
on the battery.
2. Remove the battery from the
stapler/nailer.
WARNING: THE BATTERY CAN BE WARM TO THE TOUCH WHEN REMOVED
FROM THE TOOL. ALWAYS LET THE BATTERY COOL DOWN BEFORE
RECHARGING. DO NOT RECHARGE A WARM BATTERY.
Summary of Contents for 6487058
Page 16: ......
