24
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
GEARS
Clean away grease and built-up
grime from the top and bottom roller
gear teeth, as shown in Figure 38,
with a stiff brush and degreasing
spirits.
When dry, apply a small amount of
grease to the teeth, then use the
hand crank to rotate the rollers and
distribute the lubricant.
HAND CRANK BUSHINGS
Wipe off the grease fittings next to
each hand crank hub (see Figure 39),
then use a grease gun to add a small
amount of multi-purpose grease to
the hand crank bushings.
ROLLER BUSHINGS
Remove the top roller from the
machine, then remove the bushings
from the ends of the roller (see Figure
40). Use a cloth and degreasing spirits
to clean the bushings and the ends
of the roller, then apply a thin coat of
multi-purpose grease to the roller
ends and re-install the bushings.
Use a stiff brush and degreasing spirits
to clean the rear roller bushings (see
Figure 41), then apply a small amount
of multi-purpose grease to them. Re-
install the top roller and close the
cover.
Fig. 38
Fig. 39
Fig. 40
Fig. 41
Summary of Contents for 6560000
Page 36: ......
