6
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
OPERATION
RAISING A VEHICLE
1. Make sure that the vehicle is stable and is on firm level ground with the
wheels chocked before positioning the jack directly below the lifting point.
DO NOT rely upon the vehicle handbrake alone to prevent vehicle
movement.
2. Make sure that the jack is on solid ground. If not, place a piece of solid
wood of sufficient size to provide sufficient support below the jack.
3. Consult the vehicle owners manual to ascertain the location of the lifting
points and position the jack below the designated lifting point.
4. Locate the slotted end of the jack handle on to the release valve and turn
fully clockwise to close the valve.
5. Pump the handle and raise the ram so that the jack and lifting point are in
full contact. Before proceeding further, make one last check to make sure
that:
• the jack is vertical and stable.
• there are no obstructions to the lift and that the handle can move
freely up and down.
• all personnel are in a safe position.
6. When satisfied, continue to pump the handle and lift the load to the height
required.
7. Do not let anyone reach or work below the vehicle until it is firmly
supported on suitable axle stands.
LOWERING THE VEHICLE
1. The lowering speed is controlled by the amount you turn the release valve.
With the axle stands removed, check to make sure that there are no
WARNING: MAKE SURE THAT THE SAFETY PRECAUTIONS ARE STRICTLY
FOLLOWED. NO RESPONSIBILITY CAN BE ACCEPTED FOR INCORRECT USE
OF THE JACK
WARNING: ALWAYS LOWER IN A SLOW AND CONTROLLED MANNER, AND
CHECK THAT THERE ARE NO OBSTACLES IN THE PATH OF THE LOAD’S
DESCENT. BE VERY CAREFUL WHEN LOWERING HEAVY LOADS.
Summary of Contents for 7620052
Page 12: ......
