Clarke 7621045, Operation & Maintenance Instructions Manual

3

SPECIFICATIONS

Model number

CTJ10GLB

Part number

7621045

Length (not including handle):

1419 mm

Width

499 mm

Height

245 mm

Height of lifting cup (minimum)

175 mm

Height of lifting cup (maximum)

686 mm

Weight

130 kg

Rated Load

10 tonne

SAFETY PRECAUTIONS

1. This jack is for lifting only, do not move a load using the jack as a dolly.

2. Always inspect the jack before use. Make sure that all parts are in good 

condition and operating smoothly, and that no cracks or distortion is 
apparent. If in doubt do not use. Have the parts replaced or consult your 
CLARKE dealer.

3. Make sure that the jack is on a firm solid base, and there is no possibility of it 

slipping when under load.

4. Make sure the load is taken by the full saddle and that the point of lift on 

the load, is of sufficient strength to support the full load adequately.

5.

Always use axle stands to stabilise the load once lifted. NEVER work on or under 
a load unless it is fully and adequately supported. NEVER rely upon the jack to 
hold the load in position.

6. Never push a load off the jack.

7. Ensure that all personnel are well clear of a load being raised, or lowered.

8. NEVER exceed the rated load for the jack (See “Specifications” on 

page 3.).

9. Do not use if an oil leak is apparent. Consult your Clarke dealer.

10. Consult the vehicle handbook to determine the correct lifting points.