Clarke 7621820, Operation & Maintenance Instructions Manual

3

SAFETY PRECAUTIONS

1. This jack is for lifting only, do not move a load using the jack as a dolly.

2. Do not use to lift people.

3. Always inspect the jack before use. Make sure that all parts are in good 

condition and operating smoothly, and that no cracks or distortion is 
apparent. If in doubt do not use. Have the damaged parts replaced or 
consult your CLARKE dealer.

4. Make sure that the jack is on a firm, solid, level base, and that there is no 

possibility of it slipping when under load.

5. Make sure the load is taken by the full saddle and that the point of lift on 

the load, is strong enough to support the load adequately.

6.

Do not work under the raised vehicle until it is supported by suitable means 
e.g. axle stands, NEVER rely on the jack to support the vehicle by itself

. 

7. Never push a load off the jack.

8. Ensure that all personnel are well clear of a load being raised or lowered.

9. Do not try to lift more than the rated load for the jack, (See “Specifications” 

on page 2.)

10. Do not use the jack if an oil leak is apparent. Consult your Clarke dealer.

11. Consult the vehicle handbook to determine the correct lifting points.

12. It is necessary that the operator watch the jack and the load during 

operation.

13. Check the condition of the labels regularly and replace as required.

14. The jack must be maintained and repaired in accordance with the these 

instructions and such work be carried out by qualified persons.

15. Do not make any adjustments to any valves on the jack.

WARNING: THE OPERATOR MUST FOLLOW ALL INSTRUCTIONS WITHIN THIS 
INSTRUCTION BOOKLET