4
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
UNPACKING AND ASSEMBLY
1. Loosen the thumbscrew in the
yoke until the lower handle can
be inserted fully into the handle
socket.
• The handle has a groove which
should engage with the thumb
screw once it is re-tightened.
• The socket in the handle will
engage with the jack control
valve at the base of the yoke.
2. Tighten the thumb screw to
secure the lower handle to the
jack.
3. Add the upper handle by sliding it
onto the lower handle until the
spring loaded pin clips in place.
Remove the travel retaining block by
pressing the handle yoke downwards
and pulling the block away.
• Take care of pinching fingers
between parts
PURGING AIR FROM THE SYSTEM
If air bubbles become trapped inside
the hydraulic system during shipping
or transport, the efficiency of the jack
will be reduced and the jack will feel
spongy.
1. Use the handle to turn the control
valve anti-clockwise, relieving the
pressure inside the jack.
Summary of Contents for 7621828
Page 12: ......
