4
UNPACKING AND ASSEMBLY
1. Remove the wire retaining clip by
pressing the handle yoke down-
wards and disengaging the clip.
2. Loosen the thumb screw in the
yoke until the lower handle can
be inserted fully into the handle
socket, ensuring the square drive
on the end of the handle,
engages fully with the square
spiggot within the housing.
3. Retighten the locating thumb
screw.
4. Connect the two halves of the
operating handle and secure with
a nut and bolt.
Summary of Contents for 7623037
Page 9: ...9 DECLARATION OF CONFORMITY...
Page 10: ...10 COMPONENT PARTS GENERAL ASSEMBLY...
Page 12: ......
