7
MAINTENANCE
BEFORE USE.
• Check the jack for damage and loose fittings. If in doubt, do not
use. Have damaged parts repaired by your CLARKE dealer.
EVERY 6 MONTHS
• Oil all joints, linkages and front wheel hubs and apply grease to the
castor bearings.
ANNUALLY
• Change the oil once a year, see below.
STORAGE
Store in a dry place, with the ram fully retracted. If stored for long periods,
inspect at least once a year, clean and re-oil. For servicing, contact your
CLARKE dealer, or CLARKE International Service Department.
CHANGING THE OIL
1. Lower the saddle as far as possible.
2. Lift off the cover as shown.
3. Remove the oil filler plug / air vent
valve.
4. Lay the jack on its side to drain the
oil into a suitable container.
5. Dispose of the oil in accordance
with local regulations.
6. Fill with Clarke hydraulic oil
available from your local dealer.
7. Replace the oil filler plug / air vent
valve.
Summary of Contents for 7623050
Page 4: ...4 PARTS IDENTIFICATION...
Page 10: ...10 DECLARATION OF CONFORMITY...
Page 11: ...11 NOTES...
Page 12: ......
