Clarke 7630386, Operation & Maintenance Instructions Manual

9

TROUBLESHOOTING

PROBLEM

CAUSE

SOLUTION

When you press 
the buttons the 
motor does not 
operate.

The power cable is not 
plugged in correctly

Insert the power cable correctly

The cut out has operated

Let the hoist cool down

Power failure

Check plug fuse

Motor hums but 
does not lift

The motor is too hot

Let it cool down

The load is more than the 
capacity of the hoist

Decrease the load

Brake has become stuck 
during storage.   

Do not use the hoist and speak to 
your Clarke dealer for advice

Brake does not 
operate, and load 
slips

Brake is worn out 

Do not use the hoist and speak to 
your Clarke dealer for advice

The cable is 
twisted frayed or
kinked

Incorrectly wound on drum.

Replace the cable.

The cable has been stored 
unwound or in bad 
conditions.   

Replace the cable.

If this does not solve your problem, please speak to the Clarke service 
department. See below

PARTS AND SERVICING

For Parts & Servicing, please contact your nearest dealer, or 

CLARKE International, on one of the following numbers.

PARTS & SERVICE TEL: 020 8988 7400

PARTS & SERVICE FAX: 020 8558 3622

or e-mail as follows:

PARTS: Parts@clarkeinternational.com

SERVICE: Service@clarkeinternational.com