INSTRUCTIONS FOR USE
ENGLISH
9099236000 - FOCUS II Micro Rider
21
7/11
MAINTENANCE
The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following chart provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be deined by the person in charge of the maintenance.
WARNING!
The procedures must be performed with the machine off and the battery disconnected.
Moreover, carefully read the instructions in the Safety chapter.
All scheduled or extraordinary maintenance procedures must be performed by qualiied personnel, or by an authorized Service
Center.
This Manual describes only the easiest and most common maintenance procedures.
NOTE
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be
consulted at any Clarke Service Center.
SCHEDULED MAINTENANCE TABLE
Procedure
Daily, after using
the machine
Weekly
Every six
months
Yearly
Battery charging
Squeegee cleaning
Brush/pad cleaning
Tank, debris collection grid and vacuum grid with loat
cleaning, and cover gasket check
Chemical Mixing System cleaning and draining (optional)
Squeegee blade check and replacement
Solution ilter cleaning
Vacuum system motor ilter cleaning
Battery (WET) luid level check
Electromagnetic brake eficiency check
(1)
Brush/pad-holder motor carbon brush check or replacement
(1)
Vacuum system motor carbon brush check or replacement
(1)
Drive system motor carbon brush check or replacement
(1)
(1) This maintenance procedure must be performed by a Clarke authorized Service Center.
MACHINE WORKING HOUR CHECK
1.
Insert the ignition key (58) and turn it to “I”.
2.
In the irst 2 seconds of machine operation, the display (71) shows the total number of working hours (scrubbing/drying)
performed by the machine.
•
Turn the ignition key (58) to “0”.
https://harrissupplyind.com - To Order Parts Call 608-268-8080
