Page 6
Clarke
®
American Sanders
American B-2 Operator's Manual
MACHINE SET-UP
How to Install the Bag Support Rod and the Dust Bag
To install the support rod and the dust bag, follow this
procedure:
1. Remove the support rod and the dust bag from the
small box.
2. Using a Phillips screwdriver, remove the screw on top
of the exhaust pipe opening. See Figure 1.
3. Remove the holding bar from inside the exhaust pipe.
4. Put the ends of the support rod in the exhaust pipe (1).
Make sure the bent ends of the rod are pointing in the
down position. See Figure 2
5. Slide the bar in position to hold the support rod (2).
See Figure 2.
6. Install the holding screw.
7. Put the opening of the dust bag over the end of the
exhaust pipe. Pull and tie the strings.
HOW TO PREPARE THE MACHINE FOR OPERATION
How to Install the Sandpaper
NOTE
: Use a sandpaper disc that has a 7" diameter and a
7
/
8
hole in the center.
1. Put the machine upside down.
2. A special wrench is in the bracket behind the motor.
Use the special wrench to remove the screw and
washer from the center of the sanding pad. See
Figure 3.
3. Put the sanding disc in position on the sanding pad.
4. Put the special washer and the holding screw in
position in the center of the sanding pad.
5. Put one hand on the sandpaper. Using the special
wrench, turn the screw clockwise with the other hand.
Make sure the screw is tight. See Figure 4.
Figure 1
Figure 2
Figure 3
Figure 4
