Clarke BOXER 100, Operation & Maintenance Instructions Manual

14

OPERATING INSTRUCTIONS

Switching the air compressor off

To switch the air compressor off,

1.

Close the outlet tap and press down on the on/off button (red button)
located on top of the pressure regulator and cut-out.

2.

Switch off the mains supply and remove the plug.

•

You should never leave the compressor air tank unattended while
under pressure.

•

Always release the pressure from the tank when not in use or prior to
storage, as described in 'Draining the reservoir' on page 15.

Removing a tool from the air hose

WARNING!

Always set the pressure regulator to zero before attempting to remove or

replace a tool.

1

Stop the power supply by pressing down on the on/off button (red button)
located on top of the pressure regulator and cut-out.

2

Close the air outlet tap and trigger the equipment (spraygun, air tool etc),
to release air from the air hose BEFORE disconnecting the hose from the
machine.

Reset button

This compressor is equipped with a thermal
overload device, which operates as a
safety device to protect the motor.

When the motor overheats for any reason,
the overload cutout automatically cuts the
power thereby preventing damage to the
motor.

Wait around 5 minutes for the motor to cool
and press the reset button. See figure 8.

If you restart the compressor and the
overload cutout activates again, switch off
the compressor, remove the plug from the
mains and have you compressor checked
by a qualified service agent.

Figure 8