Service Manual-CA60 04 Control System
19
Control Panel Removal and Installation
Control panel and control electronic board disassembly/assembly (EB1)
Disassembly
1.
Drain the recovery tank.
2.
Turn the ignition key to
“0”
and remove it.
3.
Make sure that the machine cannot move independently.
4.
Turn the recovery tank sideways, then disconnect the battery connector.
5.
Unscrew the screws (A) and carefully move the control panel (B).
6.
Disconnect the electrical connections (C) from the control electronic board (D).
7.
Unscrew the screws (E), then remove the control electronic board (D) from the control panel.
8.
If necessary, disconnect the electrical connections (F) and remove the control panel.
Assembly
9.
Assemble the components in the reverse order of disassembly.
A
B
C
C
E
F
C
E
C
D
E
C
E
Figure 5
A
Summary of Contents for CA60 20B
Page 15: ...Service Manual CA60 03 General Information 12 Dimensions Continues CA60 20D CA60 20TD Figure 4...
Page 16: ...Service Manual CA60 03 General Information 13 Dimensions Continues CA60 20B Figure 5...
Page 17: ...Service Manual CA60 03 General Information 14 Dimensions Continues CA60 24B Figure 6...