3
GENERAL SAFETY RULES
1.
NEVER
exceed the rated operating pressure for this device - 20bar (300psi).
2.
NEVER
allow the hose to retract freely. It should always be restrained to prevent the air tool
from whipping, with resultant damage to persons or property.
3.
NEVER
allow children to use the hose reel. Keep children clear of the work area at all times.
4.
ALWAYS
check for damage before using the hose. Any damage should be properly repaired
or the part replaced. Consult your local dealer.
5.
ALWAYS
ensure trailing hose does not constitute a trip hazard.
6.
ALWAYS
wear eye protection when assembling and using the hose reel.
7.
ALWAYS
take precautions with respect to the use of compressed air.
Remember....compressed air is hazardous.
8.
ALWAYS
ensure all air connections are properly sealed using teflon tape or pipe sealant.
SPECIFICATION
This CLARKE retractable air hose reel incorporates a spring driven, automatic rewind with locking
ratchet mechanism (eight locking positions per revolution).
Models: ...................................................................... CAR8MC & CAR15MC
Part Nos: .......................................................................... 3126105 & 3126100
Air Hose Size ......................... 8 metres (CAR8MC), 15 metres (CAR15MC)
Reel Air Inlet (F) ................................................................................. 1/4” BSP
Reel Air Outlet (M) ............................................................................ 1/4” BSP
Maximum Pressure: ............................................................... 20 Bar (300 PSI)
Maximum Air Flow: ............................................................................. 25 CFM
INSTALLATION
The hose reel may be mounted to a wall, floor or ceiling as required. Ensure the mounting
hardware (not supplied) and the mounting position is of sufficient strength to support the hose
and reel, plus the force required to extend the hose.
1.
Choose a suitable mounting position close enough to the compressor that the two items can
be connected together using a shorter length of hose and from where, the air compressor
can be conveniently adjusted.
2.
Mount the reel using four 1/2” bolts with washers secured through slots in the mounting
base.
The position of the hose guide bracket, (containing the roller supports), may be changed
depending upon the mounting position as illustrated on the following page.
