9
MAINTENANCE
WARNING! Make sure that the impact wrench is disconnected from the air supply before
starting any cleaning, or maintenance procedures.
D
AILY
•
Drain water from air tank, air line and compressor.
•
Pour a few drops of CLARKE Air Line Oil, into the air inlet. This should be carried out
regardless of whether or not an air line lubricator is used. If an Air line lubricator is not
used, this procedure should be repeated after every two to three hours of use.
W
EEKLY
•
Check the air inlet screen filter and
clean if necessary.
•
Remove the grub screw and insert a
few drops of oil into the oil port on the
side of the impact wrench.
CLEANING
•
Keep the body of the impact wrench
clean and free from debris, grit or
gum deposits in the tool may reduce
efficiency.
SERVICE AND REPAIR
•
All servicing and repair must be carried out by qualified service technicians.
NOTES
Please note that factors other than the tool may effect its operation and efficiency such
as reduced compressor output, excessive drain on the airline, moisture or restrictions in
the line, or the use of connectors of improper size or poor condition which will reduce air
supply.
**Clarke Air Line Oil is available from your CLARKE dealer part no. 3050825.
Air Inlet Screen
Filter (located
here)
Summary of Contents for CAT110
Page 11: ...11 DECLARATION OF CONFORMITY...
Page 12: ......
