5
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
USE OF CUTTING DISCS
1. Never use cracked or chipped cutting discs.
2. Never use non-reinforced cutting discs.
3. Only use for cutting operation Never use the side of the cutting disc for
grinding.
4. Never use a disc that is chipped, cracked or damaged. Fragments from a
broken or damaged disc can cause serious injury. Make sure that
defective discs are destroyed and not used.
5. Bonded abrasive products are breakable and shall therefore be handled
with utmost care. The use of damaged or improperly mounted or used
abrasive products is dangerous and can cause serious injuries.
6. Always refer to the label for specified usage and observe the safety
information. Do not use for purposes other than specified.
7. Always use the correct disc for its intended task. Using the incorrect disc
can cause serious injury.
8. Allow the disc and tool to do the work. Never force the disc onto the
workpiece as this could cause kickback and/or shatter the disc causing
serious injury. Kickback can occur in the event of a disc jam.
9. Do not use cutting discs for side grinding. Do not put sideways pressure on
cutting discs.
10. Do not force a disc onto a machine or alter the size of the arbor hole.
11. Abrasive products must be handled and transported with care. Abrasive
products shall be stored in such a manner that they are not subjected to
mechanical damage and harmful environmental influences. It is
recommended that discs are stored in the case provided to protect them
from damage.
TRANSPORTATION AND STORAGE
1. Never carry the tool by the air supply hose.
2. Never carry the tool with your finger on the trigger.
3. When not in use the tool should be disconnected from the air supply and
stored in a dry place out of the reach of children (preferably in a locked
cabinet).
4. Avoid storing the tool in environments where the temperature is below 0
o
C.
Summary of Contents for CAT127
Page 20: ......
