9
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
BEFORE USE
NOTE:
Ensure the compressor is turned off.
1. Remove the blanking plug from the inlet connection of the tool.
2. If required, connect an in-line mini oiler to the tool.
• A mini oiler helps to prolong the life of the air tool.
3. If a mini-oiler is not being used, run
a few drops of oil through the tool
before use. It can be entered
through the air inlet or via the hose
at the nearest connection to the
air supply.
4. Connect a suitable hose to the air
inlet as shown.
5. Connect the other end of the hose
to the compressor.
Your air tool is now ready for use.
You can fit a whip hose with a quick fit coupling if required (available from
your Clarke dealer).
FITTING THE CUTTING DISC TO THE CUT-OFF TOOL
1. Ensure the disc being fitted has a speed rating greater than 20,000 rpm
which is the maximum speed of the tool.
2. Install the disc and retaining
washer using the spanner and hex
key supplied.
NOTE:
When fitting the cutting disc,
always ensure that the side
of the disc with the metal
centre faces away from the
tool, so as to touch the
retaining washer.
WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU
ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF AIR
COMPRESSORS AND COMPRESSED AIR SUPPLIES.
Summary of Contents for CAT127
Page 20: ......
