CDM15 - Page 8
DC CURRENT MEASUREMENT
1. Set function switch to A position.
2. Set range switch to 200 mA position. Readings can
be taken from other positions, but the decimal
point will not be in correct position.
3. Open circuit to be measured, and connect leads
in series with the load in which current is to be
measured.
4. Read current value on display, along with the
polarity.
RESISTANCE MEASUREMENT
WARNING: If resistor to be measured is connected to
a circuit, ensure all power to the circuit is OFF, and all
capacitors are fully discharged before attaching test
leads.
1. Set function switch to
Ω
position.
2. Set range switch to desired position.
3. Connect test leads across resistor to be measured,
and read resistance value on display.
