7
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
BATTERY CHARGING
• The battery pack must be charged before operating the drill.
• The battery should be charged at ambient air temperatures of
between -10
o
C and 40
o
C.
TO CHARGE THE BATTERY PACK, PROCEED AS FOLLOWS.
1. Connect the charger to the mains
supply.
• The green power indicator will
light up.
2. Slide the battery onto the battery
charger.
• The green power indicator will
go out and the red charging
LED will light up.
3. When the battery is fully charged, the red charging LED will go out and the
green power LED will light up.
4. Switch off the charger at the mains and remove the battery from the
charger.
NOTE:
Whilst charging, the battery pack and charger may become warm.
This is normal and should be expected.
WARNING: WHEN THE BATTERY IS REMOVED FROM THE TOOL AFTER USE, IT
MAY BE HOT. ALWAYS ALLOW TO COOL BEFORE RECHARGING. DO NOT
RECHARGE A HOT BATTERY.
CON18LI.fm Page 7 Monday, September 3, 2012 4:29 PM
Summary of Contents for CON18LI
Page 16: ......