6
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
HOW TO CHARGE THE BATTERY
NOTE:
New batteries must be charged before use.
1. Connect the battery charger to the power supply.
2. Slide the battery charger clip into
the battery as shown.
• Charging takes approximately
90 minutes.
3. Remove the charger clip from the
battery.
4. Disconnect the charger from the
power supply.
FITTING THE BATTERY PACK
TO FIT THE BATTERY
1. Slide the battery pack into the
stapler/nailer until it clicks into
place.
TO REMOVE THE BATTERY
1. Press and hold the release buttons
on either side of the battery.
2. Slide the battery pack out of the
stapler/nailer.
WARNING: THE BATTERY CAN BE WARM TO THE TOUCH WHEN REMOVED
FROM THE TOOL. ALWAYS LET THE BATTERY COOL DOWN BEFORE
RECHARGING. DO NOT RECHARGE A WARM BATTERY.
Summary of Contents for CONSN18LI
Page 12: ......