10
OPERATION
INSERTING DRILL BITS, OR SCREWDRIVER BITS
WARNING!
Before removing, or installing a drill or screwdriver bit, make sure
that the safety locked off button is in the central locked off position.
To insert a drill bit, or screwdriver bit, proceed as follows.
1
Grip the chuck collar and rotate
the front of the chuck in an anti-
clockwise direction.
2
Place the bit in the jaws as far as it
will go.
3
Grip the chuck collar and rotate
the chuck sleeve in a clockwise
direction until it grips the bit
tightly.
OPERATING THE DRILL
The trigger switch is used to start the drill. It also controls the speed at which it
operates.
•
Make sure that the directional control switch is positioned in either the
forward, or reverse position. See page 9. The trigger switch will not
operate if the directional control switch is in the central locked off
position.
•
Squeeze the trigger switch and the drill will start.
•
The speed can be increased by increasing the pressure on the trigger.
•
The speed will increase up to the maximum speed selected on the
mechanical speed selector. (Gear 1 - 500 rpm, Gear 2 - 1400 rpm)
•
Release the trigger switch to stop the drill.
The drill is fitted with an electric brake which stops the motor when the trigger
is released.
Chuck
Chuck Collar
Summary of Contents for Contractor CON24
Page 16: ......
