12
FITTING THE AUXILIARY HANDLE
1.
Loosen the auxiliary handle by
rotating the grip section
anticlockwise a few turns.
2.
Slide the auxiliary handle over the
neck of the drill and into position
as shown.
3.
Secure the handle in place by
rotating the grip section clockwise
until the handle is held firm.
MAINTENANCE
WARNING!
Always remember to locate the direction control switch in the
central locked off position and remove the battery pack, before
cleaning the drill.
•
After use, remove the drill or screwdriver bit, open the chuck jaws and tap
the side of the chuck to remove any dust, or chippings etc.
•
Keep the cooling vents clear.
•
Clean the motor housing with a soft cloth.
•
Keep the handles clean and free from oil and grease.
•
Keep the charger clean and free from dust and grease.
•
Worn or damaged parts must be replaced by qualified personnel.
•
There are no user servicable parts inside the drill.
Summary of Contents for Contractor CON24
Page 16: ......
