7
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
5. Connect the paint hose (black) from the spray gun to the paint outlet.
6. Ensure the pressure regulator knob is turned fully anticlockwise, then turn on
the air supply from your compressor/air supply to the paint container.
7. Turn the pressure regulator knob clockwise to pressurise the container until
the required pressure is achieved.
• Working pressure will depend upon the consistency of the paint, but
must never exceed 35 psi. If the paint is sluggish at this pressure, it
should be thinned.
8. Turn on the paint outlet valve.
9. Finally, begin spraying and make adjustments to the spray pattern
according to the spray gun instructions.
10. The paint should be agitated by gentle shaking at regular intervals during
use to ensure consistency and avoid colour differences due to the paint
settling in the container.
11. Set the spray pattern and fluid flow using the adjustment screws on the
spray gun.
SPECIFICATION
Container Volume
2 Litres
Air Inlet Connection
¼”BSP
Hose Length
1700 mm
Paint Hose Dia
3/8” BSP
Safety Valve Working Pressure
35 psi
Weight
1.51 kg
Height x Diameter
322 x 129 mm
Summary of Contents for CPP2B
Page 12: ......
