Clarke Devil 6003, Operation & Maintenance Instructions Manual

7

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ELECTRICAL CONNECTIONS

DEVIL 6003 (3KW) HEATER UNITS

Connect the mains lead to a standard 230Volt 50Hz electrical supply through 
an approved 13 amp BS1363 plug or a suitably fused isolator switch.

If the plug has to be changed because it is not suitable for your socket, or due 
to damage, it should be cut off and a replacement fitted, following the wiring 
instructions shown below. The old plug must be disposed of safely, as insertion 
into a mains socket could cause an electrical hazard.

If the colours of the wires in the power cable of this product do not correspond with the 
markings on the terminals of your plug, proceed as follows.

•The BLUE wire must be 
connected to the terminal 
which is marked 

N

 or 

coloured 

Black

.

•The BROWN wire must be 
connected to the terminal 
which is marked 

L

 or 

coloured 

Red

.

•The YELLOW & GREEN 
wire must be connected 
to the terminal which is 
marked 

E 

or  

or 

coloured 

Green.

We strongly recommend that this machine is connected to the mains supply 
via a Residual Current Device (RCD).

If in any doubt, consult a qualified electrician. DO NOT attempt any repairs 
yourself.

DEVIL 6005 (5KW), DEVIL 6009(9KW) AND DEVIL 6015(15KW) UNITS

These heaters MUST be connected to a 400 Volt, 3 PHASE 50Hz supply through 
a suitably fused isolator switch. They cannot be operated from a single phase 
supply.

WARNING: READ THESE ELECTRICAL SAFETY INSTRUCTIONS 
THOROUGHLY BEFORE CONNECTING THE PRODUCT TO THE MAINS 
SUPPLY.

WARNING: THE WIRES IN THE POWER CABLE OF THIS PRODUCT ARE 
COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE:
BLUE = NEUTRAL      BROWN = LIVE     YELLOW AND GREEN = EARTH

Plug must beB1363/A approved.

Always fit 

Ensure the outer sheath of the 

Neutral

(Blue)

Live

(Brown)

Earth

(Green and 

a 13 Amp 
fuse.

cable is firmly held by the clamp

Yellow)