Common sense applies to the use of both this and any other electric power tool.
In particular we bring the following points to your attention.
ALWAYS
keep the work area clean, well lit and uncluttered.
ALWAYS
place the machine on a firm steady base and at a comfortable
working height.
Apart from the water trough which is provided to wet the cutting disk,
ALWAYS
check to ensure that all other parts of the machine and the
surrounding work area are kept dry.
ALWAYS
use in a well ventilated area. Never operate the saw in the presence
of inflammable vapours.
ALWAYS
keep children well clear of the work area at all times.
ALWAYS
examine the cutting disk before use and replace if worn.
ALWAYS
allow the motor freedom, so that the cutting disk will be cutting at, or
close to its maximum speed.
ALWAYS
use Clarke general purpose safety goggles to protect the eyes from
flying particles.
ALWAYS
take suitable precautions in respect of loose clothing, long hair and
jewellery, as these are potential hazards which could get caught up in the
moving parts of this high speed machine.
ALWAYS
use a Clarke face mask to prevent inhalation of any dust which may
be produced.
ALWAYS
disconnect from the power supply before making any adjustments to
the machine.
The use of work gloves is recommended, providing these allow you to retain
sufficient feel and sensitivity whilst operating the machine.
NEVER
force the cutting disk if it is reluctant to cut properly or tends to slow down.
NEVER
use this machine for cutting metal or vegetable matter. This machine
is for cutting stone, ceramics, marble and similar hard material ONLY.
NEVER
attempt to repair the mains cable. If it, or any part of the switch assembly
becomes damaged, then it must be replaced.
NEVER
apply side thrust to the cutting disk. i.e. try to cut on one side of the
disk only.
NEVER
operate this machine with the Disk Guard removed.
7
DO NOT
exceed the Duty Cycle - See Specifications
GENERAL SAFETY PRECAUTIONS
7
7
7
4
4
4
4
4
4
4
4
4
4
4
4
7
7
2
