8
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
OPERATION
THE WATER
Position the tray as shown and fill 3/4
full with water.
• Do not add chemicals or
detergents to the water.
• Always maintain this level (3/4
full) to ensure that there is
sufficient water in the tray for
dust suppression and cooling.
FITTING THE PARALLEL GUIDE
1. Position the parallel guide on the
work table as shown.
2. Align the hole in the fixing plate
with the hole in the end of the
parallel guide.
• The fixing plate should be fitted
on the inside surface of the
work table edges.
3. Attach it with the washer and
securing knob provided, repeat on the other end of the parallel guide.
ADJUSTING THE PARALLEL GUIDE
1. Loosen the two securing knobs
provided.
2. Adjust the parallel guide to the
desired position using the scales
on the table.
3. Re-tighten the two securing knobs.
WARNING: BEFORE USING YOUR TILE CUTTER BE SURE TO READ THE
INSTRUCTION MANUAL CAREFULLY.
Summary of Contents for ETC8
Page 12: ......
