9
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
STARTING AND STOPPING
Press the ON Button (marked “I“) to
start the tile cutter.
• Allow the tile cutter to reach full
speed before cutting any tiles.
Press the OFF Button (marked “O“) to
stop the tile cutter.
NOTE:
The disc will continue to
rotate for some time after
switching off.
MAKING A STRAIGHT CUT
Position the tile firmly against the
parallel guide and push the tile slowly
past the disc.
• Do not try to force the tile past
the disc too quickly.
MAKING A MITRE CUT
Follow the same procedure as for a
straight cut but use the mitre guide in
conjunction with the parallel guide.
• The mitre guide simply runs up
against the edge of the parallel
guide as shown.
• Ensure that the tile is held firmly
into the guide before making
the cut.
CUTTING WITH THE TABLE AT AN ANGLE
Use this facility if you wish to cut at an
angle.
1. Loosen the two table securing
knobs (one at each side of table).
2. Tilt the table to the desired angle
using the scale under the table.
3. Re-secure the table and make the
cut as before.
Summary of Contents for ETC8
Page 12: ......
