12
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
CLEANING & MAINTENANCE
1. Turn heater off and let it cool for at least 20 minutes before cleaning.
2. Keep the heater clean. Clean the heater annually or as needed to remove
dust and debris. If the heater is dirty or dusty, clean with a damp cloth. Use
household cleaners on difficult spots. To clean the reflector, remove the
screen by undoing the four securing screws at the front of the unit.
3. Inspect the heater before each use. Check the connections for leaks.
Apply a mixture of liquid soap and water to the connections. Bubbles
forming show a leak. Correct all leaks at once.
4. Clean the inside of the heater using compressed air where possible. Blow
air back and forth along the entire burner face until all dust has been
dislodged from the surface of the screen. Blow air through the venturi from
the control (orifice) end of the heater.
5. Inspect the hose/regulator assembly before each use. If the hose is highly
worn or cut it must be replaced.
6.
The heater should be inspected before each use and at l
east annually by
a qualified person.
WARNING: NEVER ATTEMPT TO SERVICE THE HEATER WHILE IT IS
CONNECTED TO THE PROPANE SUPPLY, IS OPERATING, OR IS HOT.
(SEVERE BURNS CAN OCCUR).
Summary of Contents for GRH35
Page 20: ......
