5
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
SETTING UP
SETTING UP & USAGE
NOTE: This log splitter is only designed to split dried logs.
1. Select a hard level surface, such
as a driveway or concrete floor to
create your workspace.
2. Place a flat piece of wood/board
on the hard surface. This will save
the blade and work surface from
damage.
3. The LOGBUSTER is designed to
slide within itself, a locking/transit
bolt is fitted to stop this movement
while in transit. The bolt will only
work when the inner tube (Lower Handle) is fully retracted into the outer
tube (Upper Handle)
4.
Always make sure that the
locking/transit bolt is locked in
place before lifting and
transporting the LOGBUSTER.
5. Hold the LOGBUSTER by the upper
rubber grip with one hand and
support the lower part with the
other hand when transporting.
6. Position the log to be split upright
on the work surface.
7. Still holding the upper grip and
supporting the lower part of the
LOGBUSTER, position the blade
onto the log.
Keep fingers away
from the blade tip.
Summary of Contents for LOGBUSTER M
Page 8: ......
