3
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
POWER TOOL SAFETY WARNINGS
1) WORK AREA
1.
Keep the work area clean and well lit.
Cluttered and dark areas invite accidents.
2.
Do not operate power tools in explosive atmospheres, such as in the presence of
flammable liquids, gases or dust.
Power tools create sparks which may ignite the
dust or fumes.
3.
Keep children and bystanders away while operating a power tool.
Distractions can
cause you to lose control.
2) ELECTRICAL SAFETY
1.
Power tool plugs must match the outlet. Never modify the plug in any way. Do not
use adapter plugs with earthed (grounded) power tools.
Unmodified plugs and
matching outlets will reduce the risk of electric shock.
2.
Do not expose power tools to rain or wet conditions.
Water entering a power tool will
increase the risk of electric shock.
3.
Do not abuse the cable. Never use it for carrying, pulling or unplugging the power
tool. Keep the cable away from heat, oil, sharp edges or moving parts.
Damaged or
entangled cables increase the risk of electric shock.
4.
When operating a power tool outdoors, use an extension cable suitable for outdoor
use.
Use of a cable suitable for outdoor use reduces the risk of electric shock
5.
If operating the power tool in a damp location is unavoidable, use a residual current
device (RCD) protected supply.
3) PERSONAL SAFETY
1.
Stay alert, watch what you are doing and use common sense when operating a
power tool.
Do not use a power tool while you are tired or under the influence of
drugs, alcohol or medication. A moment of inattention while operating power tools
may result in personal injury.
2.
Use safety equipment. Always wear eye protection.
Safety equipment such as dust
mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate
conditions will reduce personal injuries.
3.
Avoid accidental starting
. Ensure the switch is in the off position before plugging in.
Carrying power tools with your finger on the switch or plugging in power tools that
have the switch on invites accidents.
4.
Remove any wrench before turning the power tool on
. A wrench left attached to a
rotating part may result in personal injury.
5.
Do not overreach.
Keep proper footing and balance at all times. This enables better
control of the power tool in unexpected situations.
6.
Dress properly.
Do not wear loose clothing or jewellery. Keep your hair, clothing and
gloves away from moving parts. Loose clothes, jewellery or long hair can be caught
in moving parts.
Summary of Contents for Metalworker CBG6250L
Page 16: ......
