4
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
4) POWER TOOL USE AND CARE
1.
Do not force the power tool.
Use the correct accessories for your application. The
correct power tool will do the job better and safer at the rate which it was designed.
2.
Do not use the power tool if the switch does not turn it on and off.
Any power tool that
cannot be controlled with the switch is dangerous and must be repaired.
3.
Disconnect the plug from the power source before changing accessories, or storing
power tools.
Such preventive safety measures reduce the risk of starting the power
tool accidentally.
4.
Store idle tools out of the reach of children and do not allow persons unfamiliar with
the power tool or these instructions to operate it.
Power tools are dangerous in the
hands of untrained users.
5.
Maintain power tools
. Check for misalignment or binding of moving parts, breakage
of parts and any other condition that may affect the power tool’s operation. If
damaged, have the power tool repaired before use. Many accidents are caused
by poorly maintained power tools.
6.
Use the power tool and accessories in accordance with these instructions and in the
manner intended, taking into account the working conditions and the work to be
performed
. Use of the power tool for operations different from intended could result
in a hazardous situation.
7.
The performance of this tool may vary, depending upon variations in line voltage.
Extension cable usage may also affect performance.
5) SERVICE
1.
Have your power tool serviced by qualified service personnel using only identical
replacement parts.
This will ensure that the safety of the power tool is maintained.
BENCH GRINDER SAFETY WARNINGS
1.
Hold the hand tool or blade being sharpened firmly to prevent loss of control.
2.
NEVER install a abrasive flap wheel or sanding disc on this grinder.
3.
Always replace a cracked grinding wheel immediately.
4.
Never use damaged or incorrect grindstones. The stone and retaining bolt were
specially designed for your grinder, for optimum performance and safety of
operation. Inspect the condition of the grinding stone before use and do not use if
any damage is noticed.
5.
Do not use aluminium oxide wheels when grinding non-ferrous metals such as
aluminium or brass. Use silicon carbide wheels (not included) for grinding non-ferrous
metals.
6.
Always use the tool rests to steady the workpiece. If the tool attachments are not
used, the torque of the spinning grinding/polishing wheel may pull the workpiece
from your hands.
7.
Never leave the grinder unattended when it is connected to an electrical power
supply. Switch off the machine and unplug it before leaving.
CBG6250LW Bench Grinder.fm Page 4 Thursday, November 10, 2011 2:59 PM
Summary of Contents for Metalworker CBG6250LW
Page 16: ......
