8
PREPARATION
CONNECTING THE OUTLET HOSE
WARNING!
ENSURE THAT THE PUDDLE PUMP IS DISCONNECTED FROM THE MAINS POWER
SUPPLY BEFORE CONNECTING THE HOSE.
NOTE: The outlet hose is not supplied with the
puddle pump.
The puddle pump is supplied with a multi
hose adapter(as illustrated), for use with 25
mm (1“) and 32 mm (1 -1 /4”) hoses,
IMPORTANT!
When screwing on the adapter,
ensure the non-return valve is correcly
located so that the flap opens upwards.
The multi hose adapter allows hose to be
attached using hose clips or screw-on
adapters.
If you wish to connect a 1 “ hose using a
hose clip, simply attach it to the end of the
adapter.
If you wish to use a 1 “BSP hose adapter (for
1 “ dia. hose), cut the multi hose adapter at
point
A.
If you wish to connect a 1-1/4" hose using a
hose clip, cut the adapter at point B
If you wish to use a 1-1 /4"BSP hose adapter
(for 1-1/4" dia. hose), cut the multi hose adapter at point C.
We strongly recommend that you connect the outlet to the 1-1/4" diameter, as
any restrictions will reduce capacity, and put additional strain on the motor.
NOTE:
Please bear in mind that a hose adapter
requires the use of a rubber washer, and the
point at which the multi hose adapter is cut
(points A and C), must be perfectly clean
and square.
