-2-
-5-
Please note that the details and specifications contained herein are correct at the time of
going to print. However CLARKE International reserve the right to change specifications at any
time without prior notice. Always consult the product data plate.
SPECIFICATIONS
LAMP
Model : .................................................................................... RWL12
Part No : ...............................................................................4003005
Voltage : ................................................................................ 12v dc
Ampage : .................................................................................... 7ah
Weight : ..................................................................................... 6.0kg
CHARGER
Input : ......................................................................... 230VAC, 50Hz
Output : .................................................................................
12VDC 500mA
Sealed lead acid battery.
A fully charged battery will give approximately 5 hours of continuous
use, (Lamp Only).
Please read these instructions carefully before operating the tool
Thank you for purchasing this CLARKE Rechargeable Work Lamp.
Before using the device, please read this manual thoroughly and carefully
follow all instructions given. This is for your own safety and that of others around
you, and is also to help you achieve long and trouble free service from your
new tool.
CLARKE GUARANTEE
This CLARKE product is guaranteed against faulty manufacture for a period
of 12 months from the date of purchase. Please keep your receipt as proof of
purchase.
This guarantee is invalid if the product is found to have been abused or
tampered with in any way, or not used for the purpose for which it was
intended.
Faulty goods should be returned to their place of purchase, no product can
be returned to us without prior permission.
This guarantee does not affect your statutory rights.
Bulb Replacement
Your RWL12 uses a fluorescent 230v-20w bulb with screw type fitting, which can be
purchased locally, alternatively can be purchased from your nearest Clarke International
distributor. DO NOT substitute for a different type or size etc.
To replace the bulb, proceed as follows.
Ensure the lamp is turned off, and the 12v power cable is disconnected.
Loosen the two adjusting knobs and adjust the angle of the lamp to gain
access to the four retaining screws, (A) on the back of the lamp housing, (See Fig.2
on page 3).
Using a small phillips screwdriver, remove the four screws and store safely.
Carefully remove the lens assembly, store safely.
Gripping the base of the bulb to be removed, unscrew anticlockwise and remove,
dispose of bulb according to local authority regulations.
Fit replacement bulb in reverse order, take care when handling the bulb DO NOT
overtighten.
Reassemble the lens assembly, ensuring the screws line up with the screw holes in
the back of the lens, gently tighten all screws , DO NOT force or overtighten, if the
screws do not go back easily remove an recheck the alignment.
Your lamp is now ready for use again.
Parts
1. Safety Lens Assy ............. AU12001
2. AC charger ..................... AU12002
3. 12v Power Cable ........... AU12003
4. 12v DC Charger ............. AU12004
5. Twin Socket Adapter ...... AU12005
6. Bulb (not shown) ............. AU12006
There are no other user serviceable
parts inside the lamp, DO NOT
disassemble the unit.
PARTS & SERVICE TEL: 020 8988 7400
or e-mail as follows:
PARTS: Parts@clarkeinternational.com
SERVICE: Service@clarkeinternational.com
