5
OPERATION
CHARGING THE BATTERY
1 . Make sure the lamp is turn off before charging the battery.
2. Connect either the AC charger or DC charger to the AC & DC charging port and
charge for:
• 4-6 hours using the DC power cord and DC power supply. or
• 24-26 hours using the AC home charger. The product CANNOT be
operated when recharging using the AC home charger.
USING THE SPOTLIGHT
1. For full power light beam: Set the SPOTLIGHT SWITCH to the (I) position.
2. For half power light beam: Set the SPOTLIGHT SWITCH to the (II) position.
3. To turn it off: Set the SPOTLIGHT SWITCH to the (0) position.
USING THE FLUORESCENT WORK LIGHT
1. Set the WORK LIGHT SWITCH to the
(I) position.
•
The worklight will come on.
2. Set the WORK LIGHT SWITCH to the
(0) position.
•
The worklight will switch off.
3. Lift the bottom part of the work light
and rotate to the desired position.
Note: The worklight only rotates 270
o
do not force it round any futher.
USE THE SPOTLIGHT AS A DC POWER SUPPLY
The DC power outlet has a built-in circuit breaker which is design to activate when the
current drawn exceeds 10 amps or the
power consumption is above 120W. Do
not connect any device that draws
more than this, to the DC power outlet.
1. Insert the DC accessory you want to
power into the DC power outlet.
2. Turn on the DC accessory and start
using the accessory.
•
If the built-in circuit breaker
cutout activates, turn off the DC
accessory and disconnect it from the spotlight. Wait for about 3-5 minutes
before trying to use the DC power outlet again.
Fig.1
Fig.2
