4
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
ASSEMBLY AND OPERATION
ASSEMBLY
Your lamp is supplied in three parts;-
• The lamp assembly with
adjustable arms,
• The G- clamp,
• The holder.
Slide the G-clamp into the slot in the
side of the holder, then slide the lamp
assembly spiggot into the holder.
SETTING UP
The G-clamp can be mounted on surfaces with varying angles and such
variations can be accomodated by the angulation of the lamp assembly.
The lamp may be rotated freely in the holder and the arms set at any angle by
slackening the pinch bolts, adjusting the angle and re-tightening.
Do not over tighten the pinch bolts.
When they are correctly tightened,
the lamp should be capable of
maintaining stability in any position.
CARE & MAINTENANCE
The lamp requires no maintenance
other than cleaning the lens. Liquid
glass cleaner may be used to clean
the lens, used sparingly and with a
soft dry cloth.
Do not allow
the LEDs or
electrical connections to get wet.
IMPORTANT: Always switch the lamp OFF and unplug from the power supply
before cleaning the lens.
1. When not in use, switch off & unplug from the power supply.
2. This product should be stored in a secure, dry place, out of the reach of
children. DO NOT leave it exposed to the elements and avoid direct
sunlight, direct heat, rain/moisture etc.
3. Keep the external surfaces clean. Avoid impact damage & do not allow
this product to come into contact with abrasive or corrosive materials.
Summary of Contents for SAM127
Page 8: ......
