3
ELECTRICAL CONNECTIONS
WARNING!
THIS PUMP MUST BE CONNECTED TO THE ELECTRICAL SUPPLY
VIA A RESIDUAL CURRENT DEVICE (RCD)
Connect the mains lead to a standard, 230 Volt (50Hz) electrical supply through
an approved 13 amp BS 1363 plug via an Residual Current Device.
WARNING! THIS APPLIANCE MUST BE EARTHED
IMPORTANT:
The wires in the mains lead are coloured in accordance with the
following code:
Green & Yellow
-
Earth
Blue
-
Neutral
Brown
-
Live
As the colours of the flexible lead of this appliance may not correspond with the
coloured markings identifying terminals in your plug proceed as follows:
• Connect the GREEN & YELLOW cord to terminal marked with a letter
“E” or Earth symbol “ ” or coloured GREEN or GREEN & YELLOW.
• Connect BROWN cord to terminal marked with “L” or coloured RED.
• Connect BLUE cord to the terminal marked with “N” or coloured BLACK.
If this appliance is fitted with a plug which is moulded onto the electric cable (i.e.
non-rewirable) please note:
1.
The plug must be thrown away if it is cut from the electric cable. There
is a danger of electric shock if it is subsequently inserted into a socket outlet.
2.
Never use the plug without the fuse cover fitted.
3.
Should you wish to replace a detachable fuse carrier, available from your
local dealer or most electrical stockists, ensure that the correct replacement
is used (as indicated by marking or colour code).
Fuse Rating
The fuse in the plug must be replaced with one of the same rating - 13amps and
this replacement must be ASTA approved to BS1362.
Cable Extension
If a cable extension is needed, it is essential to ensure that the size of the
conductors is at least the same size as those of the power cable supplied.
Do not attempt electrical installation work if you are in any doubt as
to how it should be done properly. Consult a qualified electrician.
