4
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
20. Ensure that the jack is properly maintained and lubricated at all times, and
that no corrosion is allowed to weaken it.
21. If the jack has been subjected to an abnormal load or shock, it should be
removed from service immediately and fully inspected by qualified
personnel, and passed as serviceable, before being used again.
22. When not in use, store the jack, fully lowered, in a safe, dry, childproof area.
IMPORTANT: ALWAYS ensure that the centre of gravity of the load, is centred
about the head section, before taking the full weight.
LIFTING
O
PERATIONS AND LIFTING EQUIPMENT
R
EGULATIONS 1998
This jack, depending on use, may fall within the scope of L
O
LE
R
. It is the
owner’s responsibility to determine whether or not it does and, if so, to comply
with any applicable requirements in L
O
LE
R
, for having the jack thoroughly
examined.
ENVIRONMENTAL PROTECTION
1. Take care to ensure that if hydraulic oil is spilt that it is cleaned away using
sand, or treated with absorbent granules designed for the purpose.
2. Always make every effort to contain any spillage and prevent ingress into
the local water course.
UNPACKING & ASSEMBLY
Unpack the components on a clean flat area of hard standing, and ensure
that all parts are present according to the packing list, as follows:
Visually inspect all components to ensure that no damage was suffered in
transit. Any deficiencies should be reported to your CLARKE dealer
immediately.
IMPORTANT: Due to the weight of the components, we recommend that you
get assistance during assembly.
ASSEMBLY
As supplied, the ram is extended from the cylinder body with the end of the
ram loose., i.e. not connected to the framework. The correct method of
assembly is as follows:
1. Lay the jack on its side, then pull the legs together, in a scissor action, to
allow access to the fixing point for the ram end. The cylinder will pivot on its
