9
MAINTENANCE
1. When the jack is not in use, keep the ram fully lowered and the release
valve closed.
2. Keep the jack clean and apply lubricating oil to all pivot points every three
months.
3. Frequently check oil level. For procedure See “Check Oil Level” on page 6.
4. Check the pump piston and piston rod periodically for signs of corrosion.
Clean exposed areas with a clean oiled cloth.
5. Change the oil once a year as follows
CHANGING THE OIL
1. Lower the saddle fully.
2. Loosen the two cover screws and
lift off the cover.
3. Lever off the filler plug using a flat
screwdriver.
4. Lay the jack on its side to drain the
oil into a suitable container.
5. Dispose of the oil in accordance
with local regulations.
6. Fill with Clarke hydraulic oil,
available from your local Clarke
dealer.
• Oil must be up to the edge of the hole.
7. Replace the oil filler cap.
STORAGE
Store in a dry place with the ram fully lowered. If stored for long periods,
inspect at least once a year, clean and re-oil. For servicing, contact your
CLARKE dealer, or CLARKE International Service Department.
