Clarke X-Pro CAT168, Operating & Maintenance Instructions

7

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

BEFORE USE

FITTING/REMOVING THE SANDING PAD

1. Rotate the eccentric wheel by 

hand until the locking hole can be 
seen through the slot in the front 
housing.

2. Insert the drive locking tool into the 

hole to stop the drive from 
rotating. 

3. Hold the drive locking tool firmly 

while screwing on the sanding pad 
clockwise. Make sure the sanding 
pad is tight and secure.

4. The pad can be removed by unscrewing anticlockwise.

FITTING/REMOVING THE SANDING DISC

1. Fit the backing disc to the sander 

by locking the moving drive 
spindle with the key supplied and 
screwing the disc tightly into 
place.

2. Select the disc to be used which 

MUST be correct disc with hook 
and loop backing.

3. Press the disc firmly onto the pad 

to secure it.

CONNECTING THE AIR SUPPLY

1. Connect one end of the hose to the compressed air supply.

2. Remove the protective plug from the air inlet and connect a suitable hose 

as shown.

WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU 
ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF AIR 
COMPRESSORS AND A COMPRESSED AIR SUPPLY.