3
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
GENERAL SAFETY RULES
THE WORK ENVIRONMENT
1. ALWAYS keep the work area clean and tidy.
2. ALWAYS dress appropriately - Do not wear loose clothing or jewellery. Tie
long hair out of the way.
3. ALWAYS keep children and visitors away - Do not let children handle the air
tool.
USE OF AIR POWERED TOOLS
1. ALWAYS stay alert and use common sense - do not operate this air tool
when you are tired or under the influence of alcohol, drugs or medication.
2. ALWAYS wear eye protectors when using air tools. Eye protectors must
provide protection from flying particles from the front and the side.
3. ALWAYS wear ear protectors and a dust mask when using an air hammer.
4. DO NOT overreach - keep proper footing and balance at all times.
5. DO NOT fit the air tool to a stand or clamping device that may damage it.
6. NEVER use oxygen, CO
2
, combustible gases, or any bottled gas, as a
source of power for the grease gun. This product should only be used with
a suitably rated compressed air supply.
7. DO NOT connect the air hose with your finger on the trigger of the air tool.
8. ALWAYS keep the air supply hose away from heat, oil and sharp edges.
9. DO NOT exceed the maximum pressure for the tool of 90 psi / 6.2 bar.
10. ALWAYS check hoses for leaks or excessive wear before use and ensure
that all connections are secure.
11. DO NOT use the tool for any other purpose than described in this manual.
12. DO NOT carry out any alterations or modifications to the air tool.
13. ALWAYS disconnect from the air supply when:
• Performing any maintenance.
• The tool is not in use.
CAUTION: FAILURE TO FOLLOW THESE PRECAUTIONS COULD RESULT IN
PERSONAL INJURY, AND/OR DAMAGE TO PROPERTY.
Summary of Contents for X-Pro CAT200
Page 16: ......
